All our competent cells are classified into Biosafety level 1 and are not genetic modified organisms. Only when transformed with a plasmid they become GMOs.

Most cloning strains will be dam+/dcm+ unless specifically noted in the genotype.

Yes

DH5α is equivalent to Zymo 5α. DH10B, Top10, and One Shot Top10 are equivalent to Zymo 10B.For XL-21 Blue, JM109 is the closest match and for Stbl3, HB101 is the closest match.

– Prepare fresh agar plates– Use more antibiotics in plates– Incubate plates for a shorter time after plating cells

We do not recommend diluting the competent cells. We recommend using less DNA to transform cells, or aliquot cells in smaller volumes before transformation. If absolutely necessary, cold 1X Competent Buffer (Mix & Go Transformation Kit, T3001 & T3002) should be used in the dilution.

No outgrowth is necessary when using Ampicillin or Carbenicillin for selection. However, an outgrowth step is required when using Chloramphenicol, Kanamycin, and Tetracycline because of the mode of action of the antibiotic itself. We recommend the following procedure for the outgrowth step:1. Incubate cells on ice for 5-10 min after addition of plasmid. 2. Add 4 volumes of SOC media.3. Incubate at 37°C for 60 min with gentle shaking at 200-300 rpm.4. Spread on a pre-warmed culture plate containing the appropriate antibiotic.

For Zymo 5α and Zymo 10B up to 20kb. However, transformation efficiency decreases proportionally from 10-20kb. Above 20kb, cells are difficult to transform. JM109, HB101, XJa, XJa (DE3), XJb, XJb (DE3) and TG1 can handle constructs up to 10kb.

There really is no maximum or minimum recommended DNA concentration, but we use 10 pg for quality control. However, the volume of DNA added should not exceed 5% of the cells total volume; the efficiency can decrease several fold as the volume of DNA used increases. If the DNA sample is too diluted, use our DNA Clean & Concentrator.

1. Thaw cells on ice, not room temperature.2. Incubate cells and DNA mixture on ice, not at room temperature. However, do not incubate longer then 1 hour.3. Ensure cells are still frozen when received.4. Pre-warm the culture plates at 37°C for at least 30 minutes.5. Prepare fresh LB agar plates containing the appropriate antibiotic. 6. Prepare a new DNA sample.7. Store the cells at -80°C (not 4°C or -20°C). If the freezer breaks, the cells should be OK as long as the temp does not go higher than -50°C.8. Avoid freeze/thaw cycles.

Heat shock is not necessary, however sometimes it can be beneficiary when preparing libraries or transforming XJb Autolysis E. coli strains.We recommend the following protocol for Heat Shock with Outgrowth: 1. Incubate cells on ice for 5-10 min after addition of plasmid.2. Incubate cells at 42°C for 45 seconds.3. Add 450 ml of SOC to the cells. 4. Incubate at 37°C for 60 min with gentle shaking at 200-300 rpm.5. Spread on a pre-warmed culture plate containing the appropriate antibiotic.